Do you have to bleed brakes after you change the brake pads?

i want to change the brake pads on my 95 ford escort. I was wondering do i have to bleed the brakes after i change the Pads?
Do you have to bleed brakes after you change the brake pads?
Not unless you open the system. Just don't remove any brake lines... you'll be fine.



Just remember, you have to push the caliper pistons back to make room for the thicker pads (new), when you do this, you're actually pushing brake fluid back into the master cylinder. When you first start the car, you'll need to pump the brakes a few times to fill the lines back up before they feel right. Good Luck!
Do you have to bleed brakes after you change the brake pads?
no, not unless you open up a bleeder screw or loosen a brake line
Nope, as long as you don't open a brake line or bleeder screw. You will not need to when replacing the pads on your car.
No, not unless you have open the bleeder valves or have a brake fluid leak. But if your brake fluid hasn't been flushed in many years, you'd do well to have it flushed by a shop if your going to keep the car several years.



http://www.troublecodes.net/articles/frn鈥?/a>
Not necessarily. Bleeding usually needs doing if system is opened. When pushing calipers back you will dump fluid from the master cylinder. Normally.

Since this is a safety issue, I recommend you let an expert do it.........Don't kill someone because of costs.
It is not required, however it a good idea to flush the brake lines, meaning;

1. Crack the bleeders (one at a time)

2. Monitor the master cylinder level.

3. Once the master cylinder is almost empty, refill with new brake fluid.

4. Allow each bleeder to drip until clean brake fluid appears.



禄禄禄
No. Take off the cap on the master cyl...push back the old break pads as far as they will go..this will push break fluid up the break lines and out of the master cyl. Install new pads. Slowly pump the break pedal a few times. Add break fluid..replace cap and your done. Recheck fluid and add if needed.
It is suggested but not necessary. Brake fluid is hydroscopic, meaning it will absorb moisture from the air, and reduse its %26quot;boiling%26quot; point. Brake fluid is often %26quot;forgot about%26quot; until there is a leak, but should be completely changed every couple of years.
No, but you would want to take some fluid out of the resevoir if the pads are low before pushing the piston back into its bore and per ASE they say to open the bleeder valve as you push the piston back into the bore, then check the fluid level.
No, only if the closed system is breached.
never! and people that add fluid to there reservoir when they notice its low should pay double for a brake job for being so ignorant!
You don't have to bleed them, but now is the best time to change your brake fluid. Brake fluid spoils after 2-3 years and will start to eat up the seals in your master or your calipers and wheel cylinders. Have it done professionally or get a service manual for proper procedure. Preventative maintenance is the best way to keep your car trouble free!
no, the only time you have to bleed the brakes, is if you have to change master cylinders, change wheel cylinders, replace a line or hose. by putting on brake pads or shoes, your not breaking on anything. all you have to do after you put the pads on, is pump the brakes so they will seat against the rotors. i hope this does you some good.
usually you don't as long as you don't open the bleeders to get the piston pushed back in, use a c-clamp to push the piston on the caliper back in and you won't have to open the bleeder.
99 times out of 100...